Modelling and Controlling a 5-Degree of Freedom Robotic Arm with Arduino

Authors

  • Bekir Cirak Karamanoglu Mehmetbey University
  • Mustafa Kaya Mustafa Kaya Karamanoglu Mehmetbey University

Keywords:

Spherical Lens, Ardunio controller, Photosensitive, Renewable Energy

Abstract

In this study, the control unit used in this study was the ARDUINO UNO and A4988  Motor Driver with real time clock. A program that instantly calculates of angle and angular velocity and torque for each of the 5 joints. The angle values ​​calculated by this program were converted into pulse width modulation signals and DC motor of robot joint motion system was controlled using these signals. As a result of the experiments, it was observed that more torque was obtained by using An Arduıno-based DC motor. In addition, a low cost and easily programmed control system has been obtained that monitors in real time.

Downloads

Download data is not yet available.

Author Biographies

Bekir Cirak , Karamanoglu Mehmetbey University

Engineering Faculty, Mechanical Engineering Department,
70100, Yunus Emre Campus, Karaman / TURKEY

Mustafa Kaya Mustafa Kaya , Karamanoglu Mehmetbey University

Mechanical Engineering Department of Graduate School of Natural and Applied Sciences , 70200 ,Yunus Emre Campus ,Karaman / TURKEY

Downloads

Published

2026-06-25

How to Cite

Cirak , B., & Mustafa Kaya , M. K. (2026). Modelling and Controlling a 5-Degree of Freedom Robotic Arm with Arduino. International Journal of Advanced Natural Sciences and Engineering Researches, 10(6), 188–196. Retrieved from https://as-proceeding.com/index.php/ijanser/article/view/3180

Issue

Section

Articles